Kia Carens: Lubrication System / Oil Pressure Switch Repair procedures

Removal and Installation

1.	Remove the under cover.

2.	Remove the oil drain plug, and drain the oil into a container.

Remove the oil pressure switch(A).

Tightening torque :

7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

4.	Install in the reverse order of removal

When installing the oil pressure switch, apply seal lock to the thread.

Seal lock : THREEBOND 2403

Thickness : 0.2 ~ 0.4 mm (0.008 ~ 0.016 in)

Inspection

1.	Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.

2.	Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch.

3.	If there is no continuity when a 49.0kpa (0.5kg/cm², 7.1psi) is applied through the oil hole, the switch is operating properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.

Replacement • Prolonged and repeated contact with mineral oil will result in t ...

Components 1. Gasket 2. Oil screen 3. Oil pan 4. Drain plug gasket 5. Drain plug ...

Circuit Diagram (M/T) (A/T) ...

Inspection 1. Disconnect the negative (-) battery terminal. 2. Pull out the relay from the engine compartment relay box. Power Relay (Type A) ...