Kia Carens: Lubrication System / Oil level sensor Repair procedures
When the oil sensor signal fault occurs, refer to the DTC guide.
| 2. |
Remove the oil level sensor (A) after disconnecting the oil level sensor
connector (B).
|
Tightening torque :
8.8 ~ 9.8N.m (0.9 ~ 1.0kgf.m, 6.5 ~ 7.2lb-ft)
|

|
| 3. |
Install in the reverse order of removal, with a new gaskat.
|
Removal
1.
Remove the under covers.
2.
Drain engine oil.
3.
Using the SST(09215-3C000) and remove the oil ...
Removal and Installation
Do not disassemble the oil pump (A) from timing chain cover because
it is supplied ...
Other information:
A :Wiper speed control (front)
· MIST/ – Single wipe
· OFF / O – Off
· INT / --- – Intermittent wipe
AUTO* – Auto control wipe
· LO / 1 – Low wiper speed
· HI / 2 – High wiper speed
B : Intermittent control wipe time adjustment
C :Wash with brief wipes (front)*
D : Rear wiper/washe ...
Component Location
1. Front door module
...