Kia Carens: Indicator Lights / Immobilizer Indicator Light (With Smart Key)
.png)
This indicator light illuminates for up to 30 seconds:
• When the vehicle detects the smart key in the vehicle properly while the Engine
Start/Stop Button is ACC or ON.
- At this time, you can start the engine.
- The indicator light goes off after starting the engine.
This indicator light blinks for a few seconds:
• When the smart key is not in the vehicle.
- At this time, you can not start the engine.
This indicator light illuminates for 2 seconds and goes off:
• When the vehicle can not detect the smart key which is in the vehicle while
the Engine Start/Stop Button is ON.
In this case, we recommend that you have the vehicle inspected by an authorized
Kia dealer.
This indicator light blinks:
- When the battery of the smart key is weak.
- At this time, you can not start the engine.However, you can start the engine
if you press the Engine Start/Stop Button with the smart key. (For more details,
refer to “Starting the Engine” in chapter 6).
- When there is a malfunction with the immobilizer system.
In this case, we recommend that you have the vehicle inspected by an authorized
Kia dealer.
This indicator light illuminates:
• When the vehicle detects the immobilizer in your key properly while the ignition
switch is ON.
- At this time, you can start the engine.
- The indicator light g ...
This indicator light blinks:
• When you turn the turn signal light on.
If any of the following occurs, there may a malfunction with the turn signal
system. In this case, we recommend that you have ...
Other information:
The rear parking assist system may not operate properly when:
1. Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.)
2. The sensor is covered with foreign matter, such as snow or water, or the sensor
cover is blocked. (It will operate normally when the ...
1. Turn off the engine.
2. Open the tailgate.
3. Remove the service cover using a flat-blade screwdriver.
Tail light/Back-up light (Bulb type)
4. Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with the slots on the assembly.
5. Remove ...