Kia Carens: Immobilizer System / Immobilizer Control Unit Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver crash pad lower panel.
(Refer to Body - " Crash Pad Lower Panel")
3.
Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a nut.
[Europe/General]

[UK(RHD) only]

Installation
1.
Install the immobilizer control unit after connecting the unit connector.
2.
Install the crash pad lower panel.
3.
Connect the negative (-) battery terminal.
Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the veh ...

Antenna Coil Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Electronic Parking Brake (EPB) Components and components location


Components 1. EPB Unit 2. EPB Switch 3. Brake Caliper 4. EPB Warning Lamp ...

Kia Carens RP (2013-2018) Service Manual: Description and operation


System Configuration PAS consists of 8 sensors(Front 4 EA, Rear 4EA) which are detecting the obstacles and transmit the result separated into three warning levels, the first, second and third to IPM(BCM) by Lin communication. IPM(BCM) decides the alarm level by the transmitt ...

Copyright © www.kicaman.com 2015-2023