Kia Carens: Hood / Hood Latch Release Handle Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle Repair procedures

Replacement

Using a screwdriver or remover, remove the hood release handle (A).

•	Use a 6mm hex bit to press the center until the handle easily pulls off the post.

Install in the reverse order of removal.

•	Make sure the hood latch cable is connected properly.

•	Make sure the hood locks/unlocks and opens/closes properly.

Hood Latch Release Handle Components and components location

Component Location 1. Hood latch release handle ...

Hood Latch Components and components location

Component Location 1. Hood upper latch assembly 2. Hood lower latch assembly ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Idler Repair procedures

Removal and Installation 1. Remove the drive belt. (Refer to Timing System - "Dreve Belt") 2. Remove the idler(A). Tightening torque : 42.2 ~ 53.9 N.m (4.3 ~ 5.5 kgf.m, 31.1 ~ ...

Kia Carens RP (2013-2018) Owners Manual: Air ventilation seat

The air ventilation is provided to cool the driver’s seat or front passenger's seat during hot weather by blowing air through small vent holes on the surface of the seat and seatback. While the engine is running, press the switch to cool the seat. When the operation of the air ventilation is n ...