Kia Carens: Blower / Field Effect Transistor (DATC) Repair procedures

Kia Carens RP (2013-2018) Service Manual / Heating,Ventilation And Air Conditioning / Blower / Field Effect Transistor (DATC) Repair procedures

Inspection

1.	Turn the ignition switch ON.

2.	Manually operate the control switch and measure the voltage of the blower motor.

Select the control switch to raise the voltage until high speed.

Specification

Fan Speed (Manual)	Motor Voltage (V)
1	3.8
2	4.6
3	5.9
4	7.2
5	8.3
6	9.5
7	11.3
8	Battery

4.	If the measured voltage is not within specification, substitute with a known-good field effect transistor and check for proper operation.

5.	Replace the field effect transistor if it is proved that there is a problem with it.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the connector (A) and then remove the field effect transistor (B) after loosening the mounting screws.

3.	Install in the reverse order of removal.

Blower Resistor (Manual) Repair procedures

Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor ...

Climate Control Air Filter Description and operation

Description The climate control air filter is located in the blower unit. It eliminates foreign materials and odor. The particle filter performs a role as an odor filter as well ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Cylinder Head Repair procedures

Removal Engine removal is not required for this procedure. • Use fender covers to avoid damaging painted surfaces. • To avoid dam ...

Kia Carens RP (2013-2018) Service Manual: ESP OFF Switch Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the crash pad side cover [LH] (A). 3. Remove the lower crash pad switch assembly (A) by pushi ...