Kia Carens: Blower / Blower Resistor (Manual) Repair procedures

Kia Carens RP (2013-2018) Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Resistor (Manual) Repair procedures

Inspection

1.	Measure the resistance between the terminals.

2.	The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.

3.	Install in the reverse order of removal.

Blower Motor Repair procedures

Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, ...

Field Effect Transistor (DATC) Repair procedures

Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Floor mat anchor(s)

When using a floor mat on the front floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward. WARNING The following must be observed when installing ANY floor mat to the vehicle. Ensure that the floor mats are securely attached ...

Kia Carens RP (2013-2018) Service Manual: Front Stabilizer Bar Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque: 88.2 ~ ...