Kia Carens: Intake And Exhaust System / Exhaust Manifold Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Mechanical System / Intake And Exhaust System / Exhaust Manifold Repair procedures

Removal and Installation

1.	Remove the engine cover.

2.	Disconnect the battery negative terminal.

3.	Disconnect the front and rear oxygen sensor connectors (A).

4.	Remove the front muffler. (Refer to Intake And Exhaust System - "Muffler")

Remove the heat protector (A).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Remove the exhaust manifold stay (A).

Tightening torque:

39.2 ~ 49.0N.m (4.0 ~ 5.0kgf.m, 28.9 ~ 36.2lb-ft)

Remove the exhaust manifold (A) and gasket.

Tightening torque:

29.4 ~ 41.2N.m (3.0 ~ 4.2kgf.m, 21.7 ~ 30.4lb-ft)

When installing, replace with a new gasket.

When installing the intake manifold, tighten the nuts with pre-torque first, and then tighten the nuts with specified torque in the sequence shown.

8.	Install in the reverse order of removal.

Exhaust Manifold Components and components location

Components 1. Heat protector 2. Exhaust manifold 3. Gasket 4. Exhaust manifold stay ...

Muffler Components and components location

Components 1. Front muffler 2. Center muffler 3. Main muffler 4. Gasket 5. Hanger ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Rain Sensor Repair procedures

Inspection Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor input signal. 2. If the wiper switc ...

Kia Carens RP (2013-2018) Owners Manual: Power brakes

Your vehicle has power-assisted brakes that adjust automatically through normal usage. In the event that the power-assisted brakes lose power because of a stalled engine or some other reason, you can still stop your vehicle by applying greater force to the brake pedal than you normally would. The ...