Kia Carens: Warning lights / Engine Oil Pressure Warning Light
This warning light illuminates:
- Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It remains on until the engine is started.
- When the engine oil pressure is low.
If the engine oil pressure is low:
1.Drive carefully to the nearest safe location and stop your vehicle.
2.Turn the engine off and check the engine oil level (For more details, refer
to “Engine Oil” in chapter 8). If the level is low, add oil as required. If the
warning light remains on after adding oil or if oil is not available, we recommend
that you have the vehicle inspected by an authorized Kia dealer as soon as possible.
CAUTION - Engine Oil Pressure Warning Light
- If the engine does not stop immediately after the Engine Oil Pressure
Warning Light is illuminated, severe damage could result.
- If the warning light stays on while the engine is running, it indicates
that there may be serious engine damage or malfunction. In this case,
1. Stop the vehicle as soon as it is safe to do so.
2.Turn off the engine and check the oil level. If the oil level is low, fill
the engine oil to the proper level.
3. Start the engine again. If the warning light stays on after the engine is
started, turn the engine off immediately. In this case, we recommend that you
have the vehicle inspected by an authorized Kia dealer.
This warning light illuminates:
When the engine coolant temperature is above 120°C (248°F). This means that
the engine is overheated and may be damaged.
❈If your vehicle is overheated, refer ...
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position
- It remains on until the engine is started.
When the engine oil level should be ch ...
Other information:
1. Turn the low beam on without driver aboard.
2. The cut-off line should be projected in the cut-off line shown in the picture.
3. When aiming the low beam, vertical aiming should be adjusted after adjusting
the horizontal aiming.
4. If head lamp leveling device is equipped, adjust the head lamp l ...
Description
BSD is a system that uses two magnetic wave radar sensors attached on the rear
panel to measure the distance from the vehicle in the back and senses and sets
off (visual and auditory) alarms for any vehicle coming into the blind spot.
–
...