Kia Carens: Cruise Control System / Cruise Control Switch Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Electrical System / Cruise Control System / Cruise Control Switch Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the driver airbag module. (Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")

3.	Remove the steering wheel. (Refer to Steering System - "Steering Column and Shaft")

4.	Remove the steering wheel cover (A) after loosening the screws.

5.	Disconnect the heated steering connector (A).

6.	Remove the upper remote control switch (B) after loosening the screws and connector (A).

7.	Remove the lower remote control switch (A) after loosening the screws and connector (B).

Installation

1.	Install in the reverse order of removal.

Inspection

[Measuring Resistance]

1.	Disconnect the cruise control switch connector from the control switch.

Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).

Function switch	Terminal	Resistance [kΩ ± 5%]
CANCEL	2 - 4	0.18
SET–	2 - 4	0.33
RES+	2 - 4	0.55
CRUISE	2 - 4	0.88

3.	If not within specification, replace switch.

[Measuring Voltage]

4.	Connect the cruise control switch connector to the control switch.

Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).

Function switch	Terminal	Voltage (V)
CANCEL	2 - 4	0.63 ~ 0.97
SET–	2 - 4	1.03 ~ 1.37
RES+	2 - 4	1.58 ~ 2.02
CRUISE	2 - 4	2.08 ~ 2.52

6.	If not within specification, replace switch.

Cruise Control Switch Schematic diagrams

Circuit Diagram ...

Emission Control System

...

Other information:

Kia Carens RP (2013-2018) Service Manual: Components and components location

Components 1. Windshield glass 2. Windshield glass moulding ...

Kia Carens RP (2013-2018) Owners Manual: Head lamp low beam (LHD)

1. Turn the low beam on without driver aboard. 2. The cut-off line should be projected in the cut-off line shown in the picture. 3. When aiming the low beam, vertical aiming should be adjusted after adjusting the horizontal aiming. 4. If head lamp leveling device is equipped, adjust the head lamp l ...