Kia Carens: Engine Control System / Camshaft Position Sensor (CMPS) Repair procedures
| 1. |
Check the signal waveform of the CMPS and CKPS using the GDS.
|
Specification: Refer to “Wave Form”
|
|
| • |
DON’T remove the camshaft position sensor while the engine
is running or right after engine is turned off. The part and
engine oil is hot and can cause burns.
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
| 2. |
Disconnect the camshaft position sensor connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the sensor.
[Bank 1 / Intake]
[Bank 1 / Exhaust]
|
| • |
Install the component with the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
| • |
Apply the engine oil to the O-ring.
|
|
| • |
Insert the sensor in the installation hole and be careful not
to damage.
|
|
| • |
Be careful not to damage the sensor housing and the connector.
|
| • |
Be careful not to damage the O-ring.
|
|
| 1. |
Installation is reverse of removal.
|
Camshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
Circuit Diagram
(M/T)
(A/T)
...
Description
Knocking is a phenomenon characterized by undesirable vibration and noise and
can cause engine damage. Knock Sensor (KS) is installed on the cylinder block
and senses ...
Other information:
Removal
1.
Set the front tires straight-ahead before removing the steering wheel.
If the steering wheel and the front tires are not set straight
ahead ...
Description
Continuous Variable Valve Timing (CVVT) system advances or retards the valve
timing of the intake and exhaust valve in accordance with the ECM control signal
which is calculated by the engine speed and load.
By controlling CVVT, the valve over-lap or under-lap ...
Camshaft Position Sensor (CMPS) Schematic diagrams
Knock Sensor (KS) Description and operation