Kia Carens: Blower / Blower Motor Repair procedures

Kia Carens RP (2013-2018) Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Motor Repair procedures

Inspection

1.	Connect the battery voltage and check the blower motor rotation.

2.	If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.

3.	Replace the blower motor if it is proved that there is a problem with it.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the glove box housing. (Refer to Body - "Glove Box Housing")

3.	Remove the passenger's side (A) after loosening the screw.

4.	Disconnect the connector (A) and then remove the blower motor (B) after loosening the screws.

5.	Install in the reverse order of removal.

Blower Unit Repair procedures

Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/recycling/charging station. ...

Blower Resistor (Manual) Repair procedures

Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Description and operation

Description Idle Stop & Go (ISG) function automatically switches off the engine when the car is at a standstill and the clutch is not operated and starts it again as soon as the clutch is operated. This not only reduces fuel consumption, it also lowers emissions.Idle Sto ...

Kia Carens RP (2013-2018) Service Manual: Auto Defogging Sensor (DATC only) Description and operation

Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog b ...