Kia Carens: Auto Lighting Control System / Auto Light Sensor Repair procedures

In the state of IGN1 ON, when the multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor's input.

If IGN1 ON, The BCM monitors the range of this supply and raises up a failure as soon as the supply’s voltage is out of range. Then this failure occurs and as long as this is present, the head lamp must be turned on without taking care about the sunlight level provided by the sensor.

This is designed to prevent any head lamp cut off when the failure occurs during the night.

Auto Light Switch Repair procedures

Inspection 1. Operate the auto light switch, then check for continuity between terminals of multi-function switch connector. [LHD] [RHD] ...

Auto Head Lamp Leveling Device

...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Additional instructions (messages)

When the Smart Parking Assist System is operating, a message (“Manually control steering wheel”, “Reduce speed”) may appear regardless of the parking order. The messages will appear according to the circumstances. Follow the instructions provided while parking your vehicle with the Smart P ...

Kia Carens RP (2013-2018) Service Manual: ABS Control Module Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the battery (A) and ECM (B). 3. Remove the brake fluid from the master cylinder reservoir with ...