Failure Diagnosis |
1. |
In principle, ESP and TCS controls are prohibited in case of ABS failure.
|
2. |
When ESP or TCS fails, only the failed system control is prohibited.
|
3. |
However, when the solenoid valve relay should be turned off in case
of ESP failure, refer to the ABS fail-safe.
|
4. |
Information on ABS fail-safe is identical to the fail-safe in systems
where ESP is not installed.
|
1. |
It keeps the code as far as the backup lamp power is connected. (O)
|
2. |
It keeps the code as far as the HCU power is on. (X)
|
1. |
Initial checkup is performed immediately after the HECU power on.
|
2. |
Valve relay checkup is performed immediately after the IG2 ON.
|
3. |
It executes the checkup all the time while the IG2 power is on.
|
1. |
Turn the system down and perform the following actions and wait for
HECU power OFF.
|
2. |
Turn the valve relay off.
|
3. |
Stop the control during the operation and do not execute any until the
normal condition recovers.
|
1. |
ESP warning lamp turn on for 3sec after IGN ON.
|
2. |
ESP function lamp blinks when ESP Act.
|
3. |
If ESP fail occured, ESP warning turns ON.
|
4. |
ESP OFF lamp turn on in case of
|