Kia Carens: Neutral Switch / Repair procedures

Kia Carens RP (2013-2018) Service Manual / Manual Transaxle System / Neutral Switch / Repair procedures

Inspection

1.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

2.	Disconnect the neutral position switch connector (A).

3.	Check the continuity between no. 1 and 2 terminals of neutral position switch. When the shift lever is in neutral, there should be contunuity.

4.	If necessary, repair or replace the neutral position switch.

Replacement

1.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

2.	Disconnect the neutral position switch connector (A).

3.	Remove the neutral position switch.

Replace a new one and install the neutral position switch, then connect the connector.

Tightening torque:

39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

Specifications

Specification Item Specification Current voltage 12V Working voltage 10 ~ 15V&nbs ...

Manual Transaxle Control System

...

Other information:

Kia Carens RP (2013-2018) Service Manual: General information

Basic Service Symbols There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service. Symbol Meaning Do not reuse the part. Replace a new one. ...

Kia Carens RP (2013-2018) Service Manual: Side Impact Sensor (SIS) Description and operation

Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH). Side Pressure Sensor is also called P-SIS because it detects ...