Kia Carens: Regulator / Repair procedures

Kia Carens RP (2013-2018) Service Manual / Clutch System / Regulator / Repair procedures

Removal

1.	Remove the battery. D 1.7 LP (Refer to Engine Electrical System - "Battery") D1.7 HP (Refer to Engine Electrical System - "Battery")

2.	Remove the ECM. D 1.7 LP (Refer to Engine Control/Fuel System - "Engine Control Module") D1.7 HP (Refer to Engine Control/Fuel System - "Engine Control Module")

3.	Remove the fuel filter. D 1.7 LP (Refer to Engine Control/Fuel System - "Fuel Filter") D1.7 HP (Refer to Engine Control/Fuel System - "Fuel Filter")

Remove the regulator (A) after removing pin (B).

Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

Installation

•	Be careful not to enter dust, foreign matters, etc in regulator.

•	When installing, Apply grease on a O-ring part of regulator connector.

•	When installing, O-rings of clutch tube & regulator connector should be replaced with a new one.

1.	Install in the reverse order of removal.

2.	After be equipped, perform bleeding air procedure after pouring the brake fluid. [Gasoline 1.6 / 2.0, Diesel 1.7 LP] (Refer to Clutch System - "Clutch Release Cylinder") [Diesel 1.7 HP] (Refer to Clutch System - "Concentric Slave Cylinder Assembly")

Components and components location

Components 1. Clutch switch 2. Ignition lock switch 3. Clutch pedal assembly 4. Master cylinder assembly 5. Connector (Only diesel) 6. Regu ...

Clutch Release Cylinder

...

Other information:

Kia Carens RP (2013-2018) Service Manual: Water Jacket Seperator Repair procedures

Remove and Installation 1. Remove the cylinder head assembly. (Refet to Cylinder Head Assembly - "Cylinder Head") 2. Remove the water jacket seperator (A). &nb ...

Kia Carens RP (2013-2018) Owners Manual: Emergency Commodity

There are some emergency commodities in the vehicle to help you respond to the emergency situation. Fire extinguisher If there is small fire and you know how to use the fire extinguisher, take the following steps carefully. 1. Pull the pin at the top of the extinguisher that keeps the handle from ...