Kia Carens: Delta Fixed Glass / Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body (Interior and Exterior) / Delta Fixed Glass / Repair procedures

Replacement
[Removal]
  
Put on gloves to protect your hands.
  
Use seat covers to avoid damaging any surfaces.
1.
Remove the front pillar trim.
(Refer to Interior Trim - "Front Pillar Trim")
2.
Loosen the delta fixed glass (A) mounting nuts.
Tightening torque :
3.9 ~ 4.4 N.m (0.4 ~ 0.45 kgf.m, 2.9 ~ 3.3 lb-ft)

3.
Cut out the delta fixed glass sealant using the utility knife.
  
Do not scrape down to the painted surface of the body; damaged paint will interfere with proper bonding.
  
Remove the rubber dam and fastereners from the body.
Mask off surrounding surfaces before painting.
4.
Remove the delta fixed glass.
[Installtion]
1.
With a putt knife, scrape the old adhesive smooth to a thickness of about 2mm (0.08 in.) on the bonding surface around the entire delta fixed glass flange.
  
Do not scrape down to the painted surface of the body, damaged paint will interfere with proper bonding.
Mask off surrounding surfaces before painting.
Remove the fasteners from the body.
2.
Clean the body bonding surface with a sponge dampened in alcohol. After cleaning, keep oil, grease and water from getting on the surface.
3.
With a sponge, apply a light coat of glass primer along the edge of the delta fixed glass as shown, then lightly wipe it off with gauze or cheese cloth :
  
Do not apply body primer to the delta fixed glass, and do not get body and glass primer sponges mixed up.
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the delta fixed glass properly, causing a leak after the delta fixed glass in installed.
Keep water, dust, and abrasive materials away from the primed surface.
4.
With a sponge, apply a light coat of body primer to the original adhesive remaining around the flange. Let the body primer dry for at least 10 minutes.
  
Do not apply glass primer to the body, and be careful not to mix up glass and body primer sponges.
Never touch the primed surfaces with your hands.
5.
Pack adhesive into the cartridge without air pockets to ensure continuous delivery. Put the cartridge in a caulking gun, and run a bead of sealant around the edge of the delta fixed glass (A) as shown. Apply the adhesive within 30 minutes after applying the glass primer. Make a slightly thicker bead at each corner.

6.
Install the delta fixed glass.
7.
Let the adhesive dry for at least one hour, then spray water over the delta fixed glass and check for leaks. Mark the leaking areas, let the delta fixed glass dry, then seal with sealant. Let the vehicle stand for at least four hours after delta fixed glass.
8.
Reinstall all remaining removed parts.
9.
Install the front pillar trim.
Components and components location
Component Location 1. Delta fixed glass ...

Quarter Fixed Glass
...

Other information:

Kia Carens RP (2013-2018) Service Manual: Instrument Cluster Schematic diagrams


Circuit Diagram ...

Kia Carens RP (2013-2018) Service Manual: Heated Oxygen Sensor (HO2S) Specifications


Specification HO2S [Bank 1/Sensor 1] Item Specification Heater Resistance (Ω) 2.4 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2] A/F Ratio (λ) Output Voltage(V) R ...

Copyright © www.kicaman.com 2015-2024