Kia Carens: Brake Line / Repair procedures

Kia Carens RP (2013-2018) Service Manual / Brake System / Brake Line / Repair procedures

Removal

1.	Disconnect the brake fiuid level switch connector, and remove the reservoir cap.

Remove the brake fluid from the master cylinder reservior with a syringe.

Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.

3.	Remove the wheel & tire.

Disconnect the brake tube by loosening the tube flare nut (B).

Tightening torque:

12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

Front

Rear

5.	Remove the brake hose clip (A).

Disconnect the brake hose from the brake caliper by loosening the bolt (A).

Tightening torque:

24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)

Front

Rear

Inspection

1.	Check the brake tubes for cracks, crimps and corrosion.

2.	Check the brake hoses for cracks, damage and fluid leakage.

3.	Check the brake tube flare nuts for damage and fluid leakage.

4.	Check brake hose mounting bracket for crack or deformation.

Installation

Install in the reverse order of removal.

Use a new washer (A) whenever installing.

2.	After installation, bleed the brake system. (Refer to Brake system bleeding)

3.	Check the spilled brake oil.

Components and components location

Components ...

Brake Pedal

...

Other information:

Kia Carens RP (2013-2018) Service Manual: Front Door Latch Repair procedures

Replacement 1. Remove the front door module. (Refer to Front Door - "Front Door Module") 2. Remove the front door outside handle base (A) by pushing in the lock pins located in the back. ...

Kia Carens RP (2013-2018) Owners Manual: Auto stop

To stop the engine in idle stop mode With manual transaxle 1. Decrease the vehicle speed to less than 5 km/h (3 mph). 2. Shift into N (Neutral) position. 3. Release the clutch pedal. With dual clutch transmission 1. Decrease the vehicle speed to 0 km/h. 2. Shift into D (Drive) or N (Neutral) positi ...