Kia Carens: Master Cylinder / Repair procedures

Kia Carens RP (2013-2018) Service Manual / Brake System / Master Cylinder / Repair procedures

Removal

1.	Turm ignition switch OFF and disconnect the negative (-) battery cable.

2.	Remove the battery (A) and ECM (B).

3.	Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.

Remove the brake fluid from the master cylinder reservoir with a syringe.

•	Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.

Disconnect the brake tube (A) from the master cylinder by loosening the tube flare nut.

Tightening torque

ABS : 12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

ESP : 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

6.	Remove the clutch hose (B). [MT only]

Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (A).

Tightening torque:

12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

Installation

1.	Install in the reverse order of removal.

2.	After installation, bleed the brake system. (Refer to Brake system bleeding)

Components and components location

Components 1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder ...

Brake Line

...

Other information:

Kia Carens RP (2013-2018) Owners Manual: 1. Activate Smart Parking Assist System

Press the Smart Parking Assist System button (the button indicator will illuminate). The Parking Assist System will be activated (the button indicator will illuminate). A warning sound will be heard if an obstacle is detected. Press the Smart Parking Assist System button again for more than ...

Kia Carens RP (2013-2018) Service Manual: Schematic diagrams

Block Diagram Circuit Diagram ...