Kia Carens: Rear Axle Assembly / Rear Hub - Carrier / Repair procedures

Kia Carens RP (2013-2018) Service Manual / Driveshaft and axle / Rear Axle Assembly / Rear Hub - Carrier / Repair procedures

Replacement

1.	Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.

Remove the rear wheel and tire (A) from rear hub .

Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

3.	Release the parking brake.

Remove the parking brake line.

(1)

Remove the parking brake cable (A), after removing the clip (B).

[Without EPS]

Parking brake lever in the car must be in fully loosened position.

(2)	Disconnect the EPB actuator connector (A). [With EPS]

Loosen the guide rod bolt (B) and the remove the rear caliper body (A).

Tightening torque:

21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~ 23.1 lb-ft)

[Without EPS]

[With EPS]

6.	Remove the pad return spring (D). Remove the pad retainers (C) and brake pads (B) in the caliper carrier (A).

Remove the brake caliper mounting bolts, and then place the brake caliper assembly (A) with wire.

Tightening torque:

63.7 ~ 73.5 N.m (6.5 ~ 7.5 kgf.m, 47.0 ~ 54.2 lb-ft)

Loosen the mounting screws and then brake disc (A).

Tightening torque:

4.9 ~ 5.8 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~ 4.3 lb-ft)

Loosen the bolts and then remove the hub bearing (A).

Tightening torque:

58.8 ~ 68.6 N.m (6.0 ~ 7.0 kgf.m, 43.3 ~ 50.6 lb-ft)

10.	Install in the reverse order of removal.

Inspection

1.	Check the hub for cracks and the splines for wear.

2.	Check the brake disc for scoring and damage.

3.	Check the rear axle carrier for cracks

4.	Check the bearing for cracks or damage.

Components and components location

Components 1. Rear dust cover 2. Rear wheel hub assembly 3. Rear brake disc ...

Suspension System

...

Other information:

Kia Carens RP (2013-2018) Service Manual: Description and operation

Function Of Safety Power Window When driver door power window auto-up switch is operated, safety function is activated. 1. Safety function condition When detect the force of 100N (using the 10N/mm spring) during the window rising, window is ...

Kia Carens RP (2013-2018) Owners Manual: Emergency Stop Signal (ESS)

The Emergency Stop Signal system alerts the driver behind by blinking the stop light when the vehicle is braked rapidly and severely. The system is activated when: The vehicle suddenly stops (vehicle speed is over 55km/h and the vehicle deceleration at greater than 7 m/s2) The ABS is activatin ...