Kia Carens: Interior Trim / Rear Pillar Trim Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body (Interior and Exterior) / Interior Trim / Rear Pillar Trim Repair procedures

Replacement
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the luggage side trim.
(Refer to Interior Trim - "Luggage Side Trim")
2.
Remove the third row seat belt upper anchor cap (A).
3.
After loosening the mounting bolt, then remove the third row seat belt upper anchor (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.
After loosening the mounting bolts, then remove the rear pillar trim (A).

5.
Install in the reverse order of removal.
  
Replace any damaged clips.
Rear Pillar Trim Components and components location
Component Location 1. Rear pillar trim ...

Trunk Trim
...

Other information:

Kia Carens RP (2013-2018) Service Manual: Rail Pressure Sensor (RPS) Description and operation


Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM ...

Kia Carens RP (2013-2018) Owners Manual: Window opening and closing


Type A To open or close a window, press down or pull up the front portion of the corresponding switch to the first detent position (5). Type B - Auto up/down window (if equipped) Pressing or pulling up the power window switch momentarily to the second detent position (6) completely lowers or rai ...

Copyright © www.kicaman.com 2015-2020