Kia Carens: Windows / Power windows

Kia Carens RP (2013-2018) Owners Manual / Features of your vehicle / Windows / Power windows

The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls the door’s window. The driver’s door has a master power window switch that controls all the windows in the vehicle. Also, the driver has a power window lock switch which can block the operation of rear passenger windows.

The power windows can be operated for approximately 30 seconds after the ignition key is removed or turned to the ACC or LOCK position. However, if the front doors are opened, the power windows cannot be operated even within the 30 seconds period.

✽ NOTICE

While driving with the rear windows down or with the sunroof (if equipped) in an open (or partially open position), your vehicle may demonstrate a wind buffeting or pulsation noise. This noise is a normal occurrence and can be reduced or eliminated by taking the following actions. If the noise occurs with one or both of the rear windows down, partially lower both front windows approximately one inch. If you experience the noise with the sunroof open, slightly reduce the size of the sunroof opening.

Windows
(1) Driver’s door power window switch (2) Front passenger’s door power window switch (3) Rear door (left) power window switch* (4) Rear door (right) power window switch* (5) Window opening and c ...

Window opening and closing
Type A To open or close a window, press down or pull up the front portion of the corresponding switch to the first detent position (5). Type B - Auto up/down window (if equipped) Pressing or pullin ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Intake Actuator Repair procedures


Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh air position when connecting 12V to terminal 3 and gro ...

Kia Carens RP (2013-2018) Service Manual: Repair procedures


Adjustment 1. After loosening the tail gate hinge (A) mounting bolt, adjust the tail gate by moving it up or down, or right or left. 2. Adjust the tail gate height by turning the tail gate overslam bumpers (B). ...

Copyright © www.kicaman.com 2015-2019