Kia Carens: Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Kia Carens RP (2013-2018) Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
2.
Remove the glove box housing.
(Refer to Body - "Glove box housing")
3.
Remove the passenger airbag mounting bolts (B), then disconnect the passenger airbag connector (A).

4.
Remove the crash pad.
(Refer to Body - "Main crash pad assembly")
  
Replace the crash pad which is damaged while PAB is deployed.
5.
Remove the mounting bolts from the crash pad. Then remove the passenger airbag.
  
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for at least thirty seconds before beginning work.
3.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.
Tightening torque :
4.9 ~ 7.8 N.m (0.5 ~ 0.8 kgf.m, 3.6 ~ 5.8 lb-ft)

4.
Install the crash pad.
(Refer to Body - "Main crash pad assembly")
5.
Connect the passenger airbag connector.
6.
Tighten the passenger airbag mounting bolts.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
7.
Reinstall the glove box housing.
(Refer to Body - "Glove box housing")
8.
Reconnect the battery negative cable.
9.
After installing the passenger airbag (PAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Passenger Airbag (PAB) Module Components and components location
Components ...

Side Airbag (SAB) Module Description and operation
Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment o ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Distributing the sealant


12. Immediately drive approximately 7~10km (4~6miles or, about 10min) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 60 km/h (35 mph). If possible, do not fall below a speed of 20 km/h (12 mph). While driving, if you experience any unusual vibration, ride disturbanc ...

Kia Carens RP (2013-2018) Service Manual: Console Armrest Components and components location


Component Location 1. Console armrest ...

Copyright © www.kicaman.com 2015-2025