Kia Carens: Engine Control System / Knock Sensor (KS) Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS) Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the intake manifold. (Refer to Engine Mechanical System - "Intake manifold")

3.	Disconnect the injector connector (A).

4.	Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

Installation is reverse of removal.

Knock sensor installation bolt:

18.6 ~ 24.5 N.m (1.9 ~ 2.5 kgf.m, 13.7 ~ 18.1 lb-ft)

Knock Sensor (KS) Schematic diagrams

Circuit Diagram (M/T) (A/T) ...

Heated Oxygen Sensor (HO2S) Description and operation

Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output vol ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Schematic diagrams

Schematic Diagram 1. CAN 2. MIL lamp 3. Immobilizer 4. Canister 5. Purge control solenoid valve 6. Manifold absolute pressure sensor 7. Throttle position sensor (ETC module included) 8. ETC motor 9. Injector 10. Knock sensor 11. Ig ...

Kia Carens RP (2013-2018) Service Manual: Emergency Fastening Device (EFD) Description and operation

Description Front emergency fastening device operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat and it is an equipment to make up for the existing short stroke. Front emerg ...