Kia Carens: Engine Control System / Heated Oxygen Sensor (HO2S) Specifications

Kia Carens RP (2013-2018) Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Specifications

Specification
HO2S [Bank 1/Sensor 1]
Item
Specification
Heater Resistance (Ω)
2.4 ~ 4.0 [20°C(68°F)]

HO2S [Bank 1/Sensor 2]
A/F Ratio (λ)
Output Voltage(V)
RICH
0.6 ~ 1.0
LEAN
0 ~ 0.4

Item
Specification
Heater Resistance (Ω)
Approx. 9.0 [21°C(69.8°F)]

Heated Oxygen Sensor (HO2S) Description and operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output vol ...

Heated Oxygen Sensor (HO2S) Troubleshooting
Signal Waveform ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Electronic Parking Brake (EPB) Repair procedures


Removal 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console assembly. (Refer to Body - “Floor console assembly") 3. Disconnect the EPB control ...

Kia Carens RP (2013-2018) Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting


Signal Waveform [NON-ISG] This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to dete ...

Copyright © www.kicaman.com 2015-2023