Kia Carens: Front Seat Belt / Front Seat Belt Pretensioner Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body (Interior and Exterior) / Front Seat Belt / Front Seat Belt Pretensioner Repair procedures

Replacement
  
When installing the belt, make sure not to damage the pretensioner.
1.
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
2.
After loosening the mounting bolt, then remove the front seat belt upper anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
After disconnecting the lock pin, remove the front seat belt pretensioner connector (A), loosen the mounting bolt, then remove the front seat belt pretensioner (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.
Install in the reverse order of removal.
  
Make sure the connector is plugged in properly.
Replace any damaged clips.
Front Seat Belt Pretensioner Components and components location
Component Location 1. Front seat belt pretensioner ...

Height Adjust Components and components location
Component Location 1. Height adjust ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Good driving practices


Never move the shift lever from P (Park) or N (Neutral) to any other position with the accelerator pedal depressed. Never move the shift lever into P (Park) when the vehicle is in motion. Be sure the vehicle is completely stopped before you attempt to shift into R (Reverse) or D (Drive). Ne ...

Kia Carens RP (2013-2018) Service Manual: Troubleshooting


Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower arm ball joint Low tire pressure No power assist Correct Rep ...

Copyright © www.kicaman.com 2015-2026