Kia Carens: SRSCM / Front Impact Sensor (FIS) Repair procedures
| • |
Removal of the airbag must be performed according to the precautions/
procedures described previously.
|
| • |
Before disconnecting the front impact sensor connector, disconnect
the front airbag connector(s).
|
| • |
Do not turn the ignition switch ON and do not connect the battery
cable while replacing the front impact sensor.
|
|
| 1. |
Disconnect the battery negative cable, and wait for at least three minutes
before beginning work.
|
| 2. |
Disconnect the front impact sensor connector (A).
|
| 3. |
Remove the front impact sensor mounting bolt (B).
|
| • |
Do not turn the ignition switch ON and do not contact the battery
cable while replacing the front impact sensor.
|
|
| 1. |
Install the new front impact sensor.
|
| 2. |
Tighten the front impact sensor mounting bolt.
|
Tightening torque :
8.0 ~ 12.0 N.m (0.82 ~ 1.22 kgf.m, 5.9 ~ 8.9 lb-ft)
|
|
| 3. |
Connect the front impact sensor connector.
|
| 4. |
Reconnect the battery negative cable.
|
| 5. |
After installing the Front Impact Sensor, confirm proper system operation:
| • |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed at
each center of the front door module (LH and RH) and two SIS which are installed
at each ...
Other information:
Components Location
1. Flex steering swithch
...
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position
- It remains on until the engine is started.
When the engine oil level should be checked.
If the engine oil level is low:
1. Drive carefully to the nearest safe location and stop you ...
Front Impact Sensor (FIS) Components and components location
Side Impact Sensor (SIS) Description and operation