Kia Carens: Engine Control System / ETC (Electronic Throttle Control) System Repair procedures
Throttle Position Sensor (TPS)
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Start the engine and measure the output voltage of TPS 1 and 2 at C.T.
and W.O.T.
|
Specification: Refer to “Specification”
|
|
ETC Motor
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the ETC module connector.
|
| 3. |
Measure resistance between the ETC module terminals 1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
Specification: Refer to “Specification”
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
| 2. |
Remove the resonator and the air intake hose. (Refer to Engine Mechanical
System - "Air Cleaner")
|
| 3. |
Disconnect the ETC module connector (A).
|
| 4. |
Disconnect the coolant hoses (A).
|
| 5. |
Disconnect the vapor hose (A) and bolts, and then remove the ETC module
(B) from the engine.
|
| • |
Install the component with the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
| 1. |
Installation is reverse of removal.
|
Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
| ETC module learning procedure |
When installing new ETC module or re-installing it, ETC module learning procedure
must be performed.
| 1. |
Hold the ignition key or the start button at th IG ON position during
5 seconds.
|
| 2. |
Turn ignition swich OFF and then start the engine.
|
|
DTC codes (P0638, P2110) might be displayed if ETC module learning procedure
does not performed after replacing ETC module.
|
Circuit Diagram
(M/T)
(A/T)
...
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and
is installed on the surge tank. It senses absolute pressure of the surge tank
and transfer ...
Other information:
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).
3.
Pull down rear door window glass by pre ...
The system will activate when:
1.The system is on
2.Vehicle speed is above 30 km/h (18.6 mph)
3.Other vehicles are detected in the rear side
WARNING
The Blind Spot Detection System (BSD) is not a substitute for proper and safe
driving. Always drive safely and use caution when changing lanes or back ...
ETC (Electronic Throttle Control) System Schematic diagrams
Manifold Absolute Pressure Sensor (MAPS) Description and operation