Kia Carens: Seat Belt Pretensioner / Emergency Fastening Device (EFD) Repair procedures

Kia Carens RP (2013-2018) Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work.
2.
To remove the emergency fastening device (C), keep on pushing the lock pin (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).

3.
Remove the door scuff trim.
(Refer to Body - "Door scuff trim")
4.
Remove the center pillar trim.
(Refer to Body - "Center pillar trim")
5.
Disconnect the emergency fastening device connector (A).

6.
Loosen the emergency fastening device mounting bolt (B) and remove the emergency fastening device.
Installation
1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at least thirty seconds.
3.
Install the emergency fastening device with a bolt (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the emergency fastening device connector (A).
5.
Install the center pillar trim.
(Refer to Body - "Center pillar trim")
6.
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
7.
Insert the seat belt to the emergency fastening device (A).

  
Make sure the lock pin is connected in properly.
8.
Reconnect the battery negative cable.
9.
After installing the emergency fastening device, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Emergency Fastening Device (EFD) Components and components location
Components ...

Brake System
...

Other information:

Kia Carens RP (2013-2018) Service Manual: Description and operation


Description Automatic transaxle control system relies on various measurement data to determine the current control status and determine the necessary compensation values. These values are used to control the actuators and achieve the desired control output. Operation ...

Kia Carens RP (2013-2018) Service Manual: Front Stabilizer Bar Repair procedures


Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque: 88.2 ~ ...

Copyright © www.kicaman.com 2015-2023