Kia Carens: Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Control / Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection

Check signal waveform of CKPS and CMPS using a GDS.

Specification: Refer to “Waveform”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply the engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage.

Installation is reverse of removal.

Crankshaft position sensor installation bolt:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Crankshaft Position Sensor (CKPS) Schematic diagrams

Circuit Diagram [M/T (NON-ISG)] [M/T (ISG)] [A/T (NON-ISG)] ...

Camshaft Position Sensor (CMPS) Description and operation

Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Weight of the trailer tongue

The tongue load of any trailer is an important weight to measure because it affects the total gross vehicle weight (GVW) of your vehicle. This weight includes the curb weight of the vehicle, any cargo you may carry in it, and the people who will be riding in the vehicle. And if you will tow a tr ...

Kia Carens RP (2013-2018) Service Manual: Fluid Repair procedures

Inspection Automatic Transaxle Fluid (ATF) Level Check When checking the ATF level, be careful not to allow foreign substance (like dust) to enter through the filler hole. 1. ...