Kia Carens: Driveshaft Assembly / BJ Boot Repair procedures

Kia Carens RP (2013-2018) Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Repair procedures

Replacement

1.	Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”)

2.	Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”)

3.	Remove the Dynamic damper. (Refer to Driveshaft Assembly - “Dynamic Damper”)

4.	Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.	Remove the BJ boot.

Install in the reverse order of removal.

•	Do not disassemble the BJ assembly.

•	Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.

•	The boot band should be replaced with a new one.

7.	Check the front alignment. (Refer to Suspension System - "Front Alignment")

BJ Boot Components and components location

Components 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot ban ...

Rear Axle Assembly / Rear Hub - Carrier

...

Other information:

Kia Carens RP (2013-2018) Owners Manual: LCD Display Control

The LCD display modes can be changed by using the control buttons on the steering wheel. [Type A] (1) : TRIP button for changing trip modes (2) : RESET button for resetting items [Type B] (1) : MODE button for changing modes or SELECT button for setting the selected item (2) : MOVE button for cha ...

Kia Carens RP (2013-2018) Owners Manual: Distributing the sealant

12. Immediately drive approximately 7~10km (4~6miles or, about 10min) to evenly distribute the sealant in the tire. CAUTION Do not exceed a speed of 60 km/h (35 mph). If possible, do not fall below a speed of 20 km/h (12 mph). While driving, if you experience any unusual vibration, ride disturbanc ...