Kia Carens: Charging System / Battery Sensor Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Electrical System / Charging System / Battery Sensor Repair procedures

Removal

1.	Disconnect the battery negative (-) cable.

2.	Disconnect the battery sensor connector (A).

3.	Remove the battery negative (-) cable after removing the bolt (B).

Installation

Install in the reverse order of removal.

Battery sensor cable installation bolt:

21.6 ~ 32.4 N.m (2.2 ~ 3.3 kgf.m, 15.9 ~ 23.9 lb-ft)

Battery (-) terminal l tightening nut:

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

•	For the vehicle equipped with a battery sensor, be careful not to damage the battery sensor when the battery is replaced or recharged.

1)	When replacing the battery, it should be same one (type, capacity and brand) that is originally installed on your vehicle. If a battery of a different type is replaced, the battery sensor may recognize the battery to be abnormal.

2)	When installing the ground cable on the negative post of battery, tighten the clamp with specified torque. An excessive tightening torque can damage the PCB internal circuit and the battery terminal .

3)	When recharging the battery, ground the negative terminal of the booster battery to the vehicle body.

Adjustment

Battery Sensor Recalibration Procedure

After reconnecting the battery negative cable, AMS and ISG function does not operates until the system is stabilized, about 4 hours. If disconnecting the negative (-) battery cable from the battery during repair work for the vehicle equipped with ISG function, Battery sensor recalibration procedure should be performed after finishing the repair work.

1.	Turn the Iginition switch ON and OFF.

2.	Park the vehicle for about 4 hours with the hood and all doors closed.

Battery Sensor Description and operation

Description Vehicles have many control units that use more electricity. These units control their own system based on information from diverse sensors. It is important to have a ...

Starting System

...

Other information:

Kia Carens RP (2013-2018) Service Manual: In-car Sensor (DATC only) Description and operation

Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside tempera ...

Kia Carens RP (2013-2018) Service Manual: Injector Description and operation

Description The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as it exits the nozzle. This aids in atomization of the fuel.The ECM controls both the ...