Symptom
|
Suspect Area
|
Remedy (Refer to page)
|
Water leaks from panorama sunroof
|
Deteriorated roof lid weatherstrip
|
Replace
|
Excessive roof lid-to-body clearance and improperly fitted weatherstrip
|
Adjust
|
Wind noise around panorama sunroof
|
Loose or deformed deflector, gaps in body work
|
Retighten adjust or replace
|
Noise heard when opening/ closing panoramaroof
|
Foreign particles lodged in guide rail
|
Check drive cable and guide rails for foreign particles
|
Loose guide rails and lid
|
Retighten
|
Motor runs but sunroof does not move or moves only partially
|
Foreign particles lodged in guide rail
|
Adjust or replace
|
Incorrect engagement of motor pinion with drive cable
|
Decrease in motor`s clutch slipping force
|
Increased sunroof sliding resistance or interference of sunroof with drive
cables, weatherstrip, etc. due tomal adjustment of sunroof
|
Noise in motor (clutch slipping noise from motor when sunroof is fully opened
or closed is not an unusual noise
|
Incorrect engagement of motor pinion with drive cable
|
Check pinion installation and
|
Re-tighten motor
|
Worn out or damaged motor pinion bearing
|
Replace motor assembly
|
Worn out or deformed drive cable
|
Replace
|
Door glass fails to operate up and down
|
Incorrect window glass installation
|
Adjust position
|
Damaged or faulty regulator arm or regulator
|
Correct or replace
|
Door does not open or close completely
|
Incorrect door installation
|
Adjust position
|
Defective door check assembly
|
Correct or replace
|
Door hinge requires grease
|
Apply grease
|
Hood does not open or close completely
|
Striker and latch not properly aligned
|
Adjust
|
Incorrectly installed hood
|
Adjust
|
Incorrect hood bumper height
|
Adjust
|
Water leak through windshield end rear window
|
Defective seal
|
Fill with sealant
|
Defective flange
|
Correct
|
Other information:
Power steering uses the motor to assist you in steering the vehicle. If the engine
is off or if the power steering system becomes inoperative, the vehicle may still
be steered, but it will require increased steering effort.
The motor driven power steering is controlled by the power steering contro ...
For the cigarette lighter to work, the ignition switch must be in the ACC position
or the ON position. To use the cigarette lighter:
Push the lighter all the way into the socket.
When the element has heated, the lighter will pop out to the "ready" position.
We recommend that you use parts for repl ...