Kia Carens: Cruise Control system / To set cruise control speed

Kia Carens RP (2013-2018) Owners Manual / Driving your vehicle / Cruise Control system / To set cruise control speed

1.Press the cruise button on the steering wheel, to turn the system on. The cruise indicator light will illuminate.

2.Accelerate to the desired speed, which must be more than approximately 30 km/h (20 mph).

✽ NOTICE - Manual transaxle

For manual transaxle vehicles, you should depress the brake pedal at least once to set the cruise control after starting the engine.

3.Move the lever down (to SET-), and release it at the desired speed.The cruise set indicator light will illuminate. Release the accelerator pedal at the same time. The desired speed will automatically be maintained.

On a steep grade, the vehicle may slow down or speed up slightly while going downhill.

Cruise control switch
CANCEL : Cancels cruise control operation. : Turns cruise control system on or off. RES+ : Resumes or increases cruise control speed. SET- : Sets or decreases cruise control speed. ...

To increase cruise control set speed
Follow either of these procedures: Move the lever up (to RES+) and hold it.Your vehicle will accelerate. Release the lever at the speed you want. Move the lever up (to RES+) and release it immed ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Blind Spot Detection Unit Repair procedures


Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") 3. Disconnect the BSD connector (A). 4. ...

Kia Carens RP (2013-2018) Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting


Signal Waveform [NON-ISG] This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to dete ...

Copyright © www.kicaman.com 2015-2020