Kia Carens: Cylinder Block / Rear Oil Seal Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Repair procedures

Removal

1.	Remove the transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle") (Refer to Automatic Transaxle System - "Automatic Transaxle")

2.	MT : Remove the flywheel. (Refet to Cylinder Block - "Flywheel")

3.	AT : Remove the drive plate. (Refet to Cylinder Block - "Drive Plate")

4.	Remove the rear oil seal(A).

Installation

Install the rear oil seal.

(1)	Apply engine oil to a new oil seal lip.

(2)	Using the SST(09231-H1100, 09231-2B200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

2.	MT : Install the flywheel. (Refet to Cylinder Block - "Flywheel")

3.	AT : Install the drive plate. (Refet to Cylinder Block - "Drive Plate")

4.	Install the transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle") (Refer to Automatic Transaxle System - "Automatic Transaxle")

Rear Oil Seal Components and components location

Components 1. Rear oil seal ...

Piston and Connecting Rod Components and components location

Components 1. Piston ring 2. Piston 3. Piston pin 4. Connecting rod 5. Connecting rod upper bearing 6. Connecting rod lower bearing 7. Conne ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Front Seat Belt Buckle Repair procedures

Replacement 1. Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly") 2. Disconnect the front seat belt buckle connector wiring (A). 3. After loosening the ...

Kia Carens RP (2013-2018) Service Manual: Compressor Description and operation

Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant ga ...