Kia Carens: BSD (Blind Spot Detection) / LCA (Lane Change Assist) / Operating conditions
.png)
The indicator on the switch will illuminate when the BSD (Blind spot detection)
system switch is pressed with the ignition switch ON. If the vehicle speed exceeds
30 km/h (18.6 mph), the system will activate.
If you press the switch again, the switch indicator and system will be turned
off.
If the ignition switch is turned OFF and ON the system returns to the previous
state.
When the system is not used turn the system off by pressing the switch.
When the system is turned on the warning light will illuminate for 3 seconds
on the outside rearview mirror.
The system will activate when:
1.The system is on
2.Vehicle speed is above 30 km/h (18.6 mph)
3.Other vehicles are detected in the rear side
WARNING
The Blind Spot Detection System (BSD) is not a subs ...
Other information:
Description
The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH).
When a vehicle crashes with a certain degree of frontal impact, the pretensioner
seat belt helps to reduce the severity of injury to the front seat occupants
by retracting the sea ...
Description
Front emergency fastening device operates as well as belt pretensioner at the
same time If it gets into its deploy condition after a collision. It is located
at near anchor on front seat and it is an equipment to make up for the existing
short stroke. Front emerg ...