Kia Carens: Crash Pad / Crash Pad Center Panel Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Center Panel Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the floor console assembly. (Refer to Floor Console - "Floor Console Assembly")

2.	Remove the heater & A/C control unit . (Refer to Heating,Ventilation, Air Conditioning - "Heater & A/C Control Unit (MANUAL)") (Refer to Heating,Ventilation, Air Conditioning - "Heater & A/C Control Unit (DATC)")

3.	Remove the crash pad lower panel. (Refer to Crash Pad - "Crash Pad Lower Panel")

4.	Remove the glove box housing. (Refer to Crash Pad - "Glove Box Housing")

5.	After loosening the mounting screws, then remove the crash pad center lower panel (A).

Install in the reverse order of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Crash Pad Center Panel Components and components location

Component Location 1. Crash pad center lower panel ...

Main Crash Pad Assembly Components and components location

Component Location 1. Main crash pad assembly ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Accelerator Position Sensor (APS) Description and operation

Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual ...

Kia Carens RP (2013-2018) Service Manual: Description and operation

Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module). The engine operating conditi ...