Kia Carens: Interior Trim / Center Pillar Trim Repair procedures
[Center pillar lower trim]
| • |
Put on gloves to protect your hands.
|
|
| • |
When prying with a flat-tip screwdriver, wrap it with protective
tape, and apply protective tape around the related parts, to
prevent damage.
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
to protect from marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the front door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
| 2. |
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
| 3. |
Slighty remove the front door body side weatherstrip.
|
| 4. |
Slighty remove the rear door body side weatherstrip.
|
| 5. |
Remove the center pillar lower trim.
[Type without EFD (Emergency Fastening Device)]
| (1) |
Remove the front seat belt lower anchor cover (A).
|
| (2) |
After loosening the mounting bolt, then remove the front seat
belt lower anchor (B).
|
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
|
|
| (3) |
Using a screwdriver or remover, remove the center pillar lower
trim (A).
|
[Type with EFD (Emergency Fastening Device)]
| (1) |
To remove the EFD (Emergency Fastening Device) (C), keep on
pushing the lock pin (A) as arrow direction. And then remove
the seat belt after pushing the lock pin (B).
|
| (2) |
Using a screwdriver or remover, remove the center pillar lower
trim (A).
|
|
| 6. |
Install in the reverse order of removal.
| •
|
Replace any damaged clips.
|
|
|
[Center pillar upper trim]
| • |
Put on gloves to protect your hands.
|
|
| • |
When prying with a flat-tip screwdriver, wrap it with protective
tape, and apply protective tape around the related parts, to
prevent damage.
|
| • |
Use a plastic panel removal tool to remove interior trim pieces
to protect from marring the surface.
|
| • |
Take care not to bend or scratch the trim and panels.
|
|
| 1. |
Remove the center pillar lower trim.
|
| 2. |
After loosening the mounting bolt, then remove the center pillar upper
trim (A).
|
| 3. |
Install in the reverse order of removal.
| •
|
Replace any damaged clips.
|
|
|
Component Location
1. Center pillar lower trim
2. Center pillar upper trim
...
Component Location
1. Rear transverse trim
...
Other information:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the temperature control actuator operates to the cool position
when connecting 12V ...
A :Wiper speed control (front)
· MIST/ – Single wipe
· OFF / O – Off
· INT / --- – Intermittent wipe
AUTO* – Auto control wipe
· LO / 1 – Low wiper speed
· HI / 2 – High wiper speed
B : Intermittent control wipe time adjustment
C :Wash with brief wipes (front)*
D : Rear wiper/washe ...
Center Pillar Trim Components and components location
Rear Transverse Trim Components and components location