Kia Carens: Tires/Wheels / Alignment Repair procedures

Kia Carens RP (2013-2018) Service Manual / Suspension System / Tires/Wheels / Alignment Repair procedures

Front wheel alignment

When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels facing straight ahead.

Prior to wheel alignment, steering column is approximately in tilt mid position.

Toe

B - A > 0: Toe in (+)

B - A < 0: Toe out (-)

Toe adjustment

1.	Loosen the tie rod end lock nut.

2.	Remove the bellows clip to prevent the bellows from being twisted.

Adjust the toe by screwing or unscrewing the tie rod. Toe adjustment should be made by turning the right and left tie rods by the same amount.

Toe-in

Total : 0° ± 0.2°

Individual : 0° ± 0.1°

When completing the toe adjustment, install the bellows clip and tighten the tie rod end lock nut to specified torque.

Tightening torque:

49.0 ~ 53.9 N.m (5.0 ~ 5.5 kgf.m, 36.2 ~ 39.8 lb-ft)

Camber and Caster

Camber and Caster are pre-set at the factory, so they do not need to be adjusted. If the camber and caster are not within the standard value, replace or repair the damaged parts and then inspect again.

Camber angle : -0.5° ± 0.5°

Caster angle : 4.42°

Wheel Repair procedures

Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Tire Pressure Monitoring System

...

Other information:

Kia Carens RP (2013-2018) Service Manual: Components and components location

Component Location 1. Front height motor 2. Extension motor 3. Slide motor 4. Rear height motor 5. Lumbar support motor 6. Recline motor 7. Extension switch 8. Power seat switch 9. Recline switch 10. Lumbar support switch ...

Kia Carens RP (2013-2018) Service Manual: Intake Air Temperature Sensor (IATS) Description and operation

Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of the air temperature is needed because air density varies according to the temperat ...